How to clean your grouphead.

Written by jon stovall

Wednesday, 12 May 2004

this is a pictorial guide on how to clean your grouphead on your pulser. you would be surprised how easy it actually is. in fact it takes longer to build a picture guide than it does to clean your group head. after reading this you will have no excuse for a dirty group. step one: make your group head dirty step two: pry out the group head. use a towel or something to "pad" the group as you pry the screen out by the groove. possible tools: paint can opener, flathead screw driver, etc. step three: scrub the screen with a brush. NO SOAP - just friction. the screen after cleaning. step four: scrub the group with a brush. NO SOAP - just friction. the group after cleaning. step five: re-assemble the screen and gasket parts and replace in the group. lock in the PF a couple of times to make sure everything is seated properly. also pull a couple of blank shots to check it out. then pull a sink shot to season all the metal. Make another shot and savor the flavor of your clean group. enjoy.

Last Updated ( Wednesday, 14 February 2007 )

 

Next >